We make it easy to get Professional Appliance Repair services. Call now to speak with a specialist in Firebaugh, CA.
Call 24/7, 365 days for
Get a clear estimate based
on your requirements.
Our service network includes
local coverage in Firebaugh, CA.
Call 24/7 to book an in-person Appliance Repair consultation.
An Appliance Repair Specialist will complete an inspection and give you an Estimate.
A full report of the tasks completed will be given to you.
My dryer isn’t heating at all. What could be the problem?
Check the circuit breaker to make sure you have the correct power to the dryer. On some brands of dryers the motor will run, but will not heat.
The circuit breaker for the dryer is 240 volts and the motor requires 120 volts to operate. The remaining 120 volts is required to power up the element on an electric dryer.
The temperature of my oven doesn't match the guage, Is there a way to calibrate it?
Yes. In most cases we can calibrate oven temperature in the electronic section of your stove.
What kinds of appliances do you repair?
Most major brand washers, dryers, refrigerators, freezers, dishwashers, ranges, ovens, gas and electric stoves, range hoods and garbage disposals.
Why are the sides of my refrigerator or freezer sometimes hot to the touch?
Some model refrigerators have part of the condenser coils foamed into the walls of the cabinet.
If the refrigerator or freezer has a forced air condenser under the unit and the coils are not cleaned, the sides of the refrigerator will be warm.
Also, if the ambient temperature of the unit is warmer than normal this could cause the side walls of the unit to be warmer than normal.
In most cases you will need to clean out the coils under the refrigerator. If problem persists call for service immediately or major damage may occur.
Why does my dryer take so long to dry?
This condition is usually caused by either kinked vent tubing, a restriction in the vent or too long of venting material from the area of where the dryer is located to the vent outside of the house. If the venting material is too long, the venting material should be shortened as much as possible. If the venting material appears to be short enough, you may have a restriction in the vent or the distance from the dryer vent to the outside is too long of a run. A quick way to test the vent airflow is to turn on the dryer without any clothes in the dryer. The amount of airflow should be equal to the amount of air exhausting from the dryer without the vent attached.
If the problem persists, call us immediately to set up a service call.